Answer the following questions in about 150 words each :
Describe the various components of the drip irrigation system with the help of a schematic diagram.
10 marks · answer in 150 words · directive: Describe
The core of a good answer
A drip system delivers water drop by drop to the root zone through a chain of components: water source and pump, a head control unit (filters, fertiliser injector, valves and gauges), a pipe network (main, sub-main, laterals) and emitters, with flush and air release valves for maintenance.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
The question wants the parts of a drip system named in the order water flows through them, with the function of each, and a labelled schematic. The diagram is a simple line sketch from source to emitters; the text should explain each block.
Answer outline
Introduction
Drip or trickle irrigation applies water slowly at low pressure directly near the plant root zone; its components can be shown as a flow line from source to plant.
Schematic to draw (in words)
- Water source (well, tank, farm pond) then pump then head control unit (non-return valve, sand separator or hydrocyclone, media filter, fertiliser tank or venturi injector, screen or disc filter, pressure gauges, control valve) then PVC main line then sub-main lines then polyethylene laterals along crop rows then emitters near each plant; flush valves at the ends of sub-mains and laterals and an air release valve at the high point.
Water source and pumping unit
- Pump supplies water at the required low operating pressure; an overhead tank can serve small systems by gravity.
- Non-return valve prevents backflow of water and fertiliser into the source.
Head control unit
- Hydrocyclone or sand separator removes sand from well water; sand or media filter removes organic matter and algae from open water.
- Screen filter or disc filter is the final filter protecting emitters from clogging.
- Fertiliser tank, venturi injector or dosing pump for fertigation and acid or chlorine treatment.
- Pressure gauges before and after filters show when backwashing is needed; pressure regulators and control valves keep pressure uniform.
Distribution network and emitters
- Main line and sub-main lines of rigid PVC or HDPE, usually buried, carry water to each block.
- Laterals of smaller diameter polyethylene tubing run along rows.
- Emitters: online drippers, inline drippers or drip tape, pressure compensating types for slopes; microtubes and micro-sprinklers are variants.
- Flush valves to clean out sediment and air release or vacuum relief valves to prevent air locks and suction of soil into emitters.
Conclusion
Each component serves either clean water delivery or uniform pressure; good filtration and periodic flushing decide the life of the system and its water saving.
Examples and data to cite
- Per Drop More Crop component of Pradhan Mantri Krishi Sinchayee Yojana (PMKSY, launched 2015-16) subsidises drip and sprinkler systems.
Facts to remember
- Clogging is the main operational problem; filtration and acid or chlorine treatment control it.
- Drip allows fertigation, keeps foliage dry and reduces weed growth between rows.
- Drip operates at lower pressure than sprinkler systems, lowering energy use.