Write short notes on/answer the following in about 150 words each :
Preparation of meat emulsion and precautions required during the process
10 marks · answer in 150 words · directive: Write a short note
The core of a good answer
A meat emulsion is really a batter of fine fat particles dispersed in a continuous phase of salt-extracted myofibrillar protein, water and salt; it is made by chopping lean meat with salt, phosphate and ice first and adding fat later, while keeping the batter cold and avoiding over-chopping so that the emulsion does not break.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
The note should explain the principle, the stepwise preparation in a bowl chopper or emulsion mill, and the precautions that keep the emulsion stable. Naming products made from emulsions completes it.
Answer outline
Introduction
Meat emulsions are the base of finely comminuted sausages; strictly they are batters in which solid fat particles are dispersed in a liquid continuous phase, and myosin is the protein that holds them together (Knipe, 1987, cited by Ohio State University Meat Science).
Principle
- Salt solubilises myosin, the major structural protein of meat and the most important for fat emulsification; a 7 percent brine is ideal, which with lean of 65 percent moisture means about 4.5 percent salt on lean weight.
- Phosphates, especially long-chain tripolyphosphate and hexametaphosphate, add charge so that the proteins bind more water.
- The extracted proteins must surround the finely chopped fat particles before cooking; on heating they set and hold fat and water.
Preparation
- Select fresh, cold lean meat; pre-rigor meat is valuable because at slaughter its myosin is in a readily usable state.
- Bowl chopping step 1: add lean meat, then salt (about 4.5 percent of lean weight), phosphate and curing salt with ice; ice instead of water keeps the batter at about -2 to -1 °C (28 to 30 °F) and improves protein extraction.
- Step 2: chop to about 7 °C (45 °F), then add fat, high-collagen meats and the remaining ice or water; add spices and binders; chop to a smooth batter.
- Stuff into casings and cook, then chill.
Precautions
- Control the end-point temperature: about 13 to 16 °C (55 to 60 °F) for batters with mainly pork fat; chopping pork-fat batters to higher temperatures usually gives fat caps.
- Avoid over-chopping: if fat is chopped too much its surface area becomes too large for the available protein to coat, and too many fat cells are broken.
- Ensure enough salt-soluble protein for the amount of fat, and follow the order of adding lean first and fat later.
- Do not cook too fast, at too high a relative humidity or to too high a final temperature, which causes the emulsion to break.
- Keep strict hygiene and cold conditions because comminuted meat spoils quickly.
Conclusion
A stable emulsion depends on extracted myosin, low temperature, correct ingredient order and controlled chopping and cooking; failure shows as fat separation and fat caps.
Examples and data to cite
- Ohio State University Meat Science recommends adding salt at 4.5 percent of lean meat weight to approach the 7 percent brine ideal for myosin extraction.
- Final batter temperatures of 55 to 60 °F (about 13 to 16 °C) are advised for products with predominantly pork fat.
Facts to remember
- Myosin is the most important meat protein for fat emulsification.
- Proteins must coat the fat particles before cooking for the batter to be stable.
- Over-chopping and excessive temperature rise are the main causes of emulsion breakdown.