Write short notes on/answer the following in about 150 words each :
Disposal and utilization of rabbit fur
10 marks · answer in 150 words · directive: Write a short note
The core of a good answer
Rabbit fur is used as dressed pelts for garments, as shorn hair for felting and textiles and as Angora wool for fine knitwear; skins and hair that cannot be graded are recycled as glue or fertiliser, and rabbits that die of disease are burnt or buried promptly.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
The note must cover both how rabbit fur is harvested and turned into products and how unusable fur and processing wastes are disposed of safely.
Answer outline
Introduction
Rabbits yield meat, pelts and, in Angora breeds, fine wool; the value of the fur depends on season, handling and grading (FAO).
Harvesting
- Angora rabbits: hair collected every 90 to 100 days by cutting with scissors or shears, or by depilation (plucking), which gives more even regrowth.
- Meat and fur rabbits: skin removed after slaughter by an incision across the hind legs and pulling off the skin; knife marks, grease and bloodstains lower value; head skin is discarded.
- The mature winter coat gives the best pelts; pelts from moulting animals are unstable and unfit for fur.
Preservation and processing
- Pelts are shaped on a board or steel wire frame, without over-stretching or creases.
- Drying is the only preservation used: started at once, in shade and airy conditions (18 to 22 °C, about 65 percent relative humidity); above 50 °C the collagen is damaged.
- Delay in drying or piling fresh pelts lets enzymes and bacteria loosen the hair roots, so hair falls out (hair slip).
- Dressing with a blend of salt, alum and formol, then fleshing, thinning, greasing and finishing.
Utilisation
- Grade 1 pelts are dressed for fur garments; a coat needs 20 to 30 skins; rabbit fur is used mostly for hats and coats.
- Grade 2 pelts are machine-shorn for textiles or felting, and good shorn hair is used in glove making.
- Angora wool, similar to cashmere in fineness (14 to 16 micrometres), goes into insulating underclothes and high-value woollens; about 10 percent Angora blended with wool, cotton or synthetics gives a very soft fabric.
- Low-grade fur can be used for small toys, a minor use.
Disposal
- Shorn pelts can be cut into strips and made into glue or fertiliser; ungradable waste skins are usable only as fertiliser.
- Rabbits that die of disease should be burnt at once, or buried soon after post-mortem, and nest-box bedding burnt, to stop disease spread.
- Rabbit manure and leftover feed can be vermicomposted.
Conclusion
Prompt drying, correct grading and recycling of waste skins turn rabbit fur from a disposal problem into income.
Examples and data to cite
- The North Temperate Regional Station of ICAR-Central Sheep and Wool Research Institute at Garsa, Kullu, carries out research and development on Angora rabbits.
- The Rex is the only rabbit bred mainly for its fur, and only in small numbers (FAO).
- TNAU advises shearing Angora rabbits at 10 to 11 week intervals when the wool is 5 to 6 cm long, avoiding the coldest days of December and January.
Facts to remember
- Pelts must be dried promptly to prevent hair slip.
- Pelts from moulting animals are unstable and unsuitable for fur.
- Angora hair must be clean; low-grade Angora hair is worth at most 5 to 6 percent of first-quality hair.
- Angora wool is harvested every three to four months to prevent wool block.