Spontaneous adsorption of gas on solid surface favours low temperature. Explain, why.
5 marks · directive: Explain
The core of a good answer
Adsorption is spontaneous (ΔG < 0) but involves a decrease in entropy (ΔS < 0) because gas molecules lose freedom of motion when fixed on the surface; so ΔH must be negative (exothermic), and since ΔG = ΔH − TΔS, the unfavourable −TΔS term grows with T, so adsorption is favoured at low temperature, as Le Chatelier's principle also predicts.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
A thermodynamic explanation is expected: sign of ΔS, deduce sign of ΔH, then the temperature effect through ΔG = ΔH − TΔS, supported by the Le Chatelier view and adsorption isobars.
Answer outline
Introduction
Adsorption is the accumulation of gas molecules at a solid surface; it is a surface equilibrium: gas + surface ⇌ adsorbed gas.
Entropy decreases
- A free gas molecule has three translational degrees of freedom; on the surface it is confined to two dimensions or fixed to a site.
- Hence ΔS(adsorption) < 0.
Enthalpy must be negative
- For a spontaneous process ΔG = ΔH − TΔS < 0.
- With ΔS < 0, the term −TΔS is positive, so ΔG can be negative only if ΔH is negative and |ΔH| > T|ΔS|.
- So adsorption is always exothermic: typical physisorption binding energies are about 10 to 300 meV (roughly 1 to 29 kJ mol⁻¹), while chemisorption bonds are about 1 to 10 eV (roughly 96 to 965 kJ mol⁻¹).
Effect of temperature
- As T increases, −TΔS becomes more positive and ΔG less negative; above T = ΔH/ΔS adsorption is no longer spontaneous.
- Le Chatelier: for an exothermic equilibrium, raising T shifts it backwards (desorption).
- Adsorption isobars: the extent of physisorption falls steadily with rise of temperature; desorption by heating is used to regenerate adsorbents.
Note on chemisorption
- Chemisorption may need activation energy, so the amount adsorbed can first rise with temperature (rate effect) before falling; at equilibrium it still decreases with temperature because it is exothermic.
Conclusion
Thus low temperature favours spontaneous adsorption because the process is exothermic and entropy reducing; this underlies cryogenic adsorption, for example charcoal cooled to low temperature to take up residual gases.
Examples and data to cite
- In 1905 Dewar and J. A. Fleming investigated the gas absorbing power of charcoal cooled to low temperatures, and the effect was applied to producing high vacuum.
- BET surface area measurements are made with N₂ adsorption at 77 K, its boiling point, because physisorption is significant only at low temperature.
Facts to remember
- ΔG = ΔH − TΔS
- Adsorption: ΔS < 0, ΔH < 0
- Physisorption binding energy about 10 to 300 meV; chemisorption about 1 to 10 eV
- Freundlich and Langmuir isotherms: extent of adsorption increases with pressure, decreases with temperature