Pratidin
2026 · Civil Engineering Optional Paper I · 10 marksMainsQuestion 5b

The nominal flow rate of water over a weir is 2 m³/s. A 1 : 10 scale model of the weir is tested in a water channel. Answer the following :
(i) What is the expected flow rate for the model?
(ii) If a force of 12 N is measured on the model, what force would be expected on the prototype?

10 marks · directive: Answer

Answer

The core of a good answer

(i) Model discharge Qm = Qp/Lr^2.5 = 2/10^2.5 = 0.00632 m³/s (about 6.32 litres per second); (ii) prototype force Fp = Fm × Lr³ = 12 × 1000 = 12,000 N = 12 kN, using Froude similarity with water in both model and prototype.

An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work

What the question asks

The question tests dynamic similarity for free surface flow. Flow over a weir is governed by gravity and inertia, so the model must be run at the same Froude number as the prototype. The answer must state why Froude (not Reynolds) similarity is chosen, derive the scale ratios for discharge and force, and then apply them.

Answer outline

Introduction

Given: prototype discharge Qp = 2 m³/s, length scale Lr = Lp/Lm = 10, model force Fm = 12 N, same fluid (water) in model and prototype so ρr = 1 and gr = 1.

Step 1: Choose the similarity law

Step 2: Discharge ratio

Step 3: Force ratio

Step 4: Other useful Froude ratios

Conclusion

The model should pass 0.00632 m³/s and a 12 N model force corresponds to 12 kN on the prototype. Check: Qm × 316.23 = 2.000 m³/s, which restores the prototype discharge.

Examples and data to cite

Facts

Facts to remember

Sources used for the explanation

Write a timed answer in the app