A sedimentation tank is treating 5 million litres of sewage per day containing 250 ppm of suspended solids. The tank removes 60 percent of the suspended solids. Calculate the quantity of sludge produced per day in bulk (volume) and weight, if the :
(i) moisture content of the sludge is 97 percent,
(ii) moisture content of the sludge is 96 percent, and
(iii) specific gravity of the wet sludge is 1.02.
Calculate the volume of sludge produced for both moisture contents and the percentage reduction in volume of sludge produced for 1.0 percent reduction in moisture content (wet sludge).
20 marks · directive: Calculate
The core of a good answer
Dry solids removed = 750 kg/day; at 97% moisture the wet sludge weighs 25000 kg/day (24.5 m³/day) and at 96% it weighs 18750 kg/day (18.4 m³/day), so a 1% reduction in moisture (97% to 96%) cuts sludge volume by 25%.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
A mass balance on suspended solids gives the dry solids; the moisture content converts dry mass to wet mass, and the specific gravity of wet sludge converts mass to volume. The last part shows the large effect of small changes in moisture on sludge volume.
Answer outline
Introduction
Flow 5 × 10⁶ l/day; SS 250 mg/l; removal 60%; wet sludge specific gravity 1.02 (density 1020 kg/m³).
Step 1: Dry solids removed
- SS load = 5 × 10⁶ l × 250 mg/l = 1250 kg/day
- Removed = 0.60 × 1250 = 750 kg/day
Step 2: (i) 97% moisture
- Solids are 3% of wet sludge: wet mass = 750/0.03 = 25000 kg/day = 25 t/day
- Volume = 25000/(1.02 × 1000) = 24.51 m³/day
Step 3: (ii) 96% moisture
- Solids are 4%: wet mass = 750/0.04 = 18750 kg/day = 18.75 t/day
- Volume = 18750/1020 = 18.38 m³/day
Step 4: Percentage reduction in volume
- Reduction = (24.51 − 18.38)/24.51 × 100 = 25%
- General: V₂/V₁ = (100 − p₁)/(100 − p₂) = 3/4
Conclusion
Sludge: 25 t (24.5 m³) per day at 97% moisture and 18.75 t (18.4 m³) per day at 96%; a 1% fall in moisture content reduces volume by 25%. Check: dry solids 750 kg are the same in both cases (25000 × 0.03 = 18750 × 0.04 = 750).
Examples and data to cite
- This large effect of moisture is why sludge treatment commonly includes thickening, dewatering and drying steps.
Facts to remember
- 1 ppm = 1 mg/l for dilute aqueous solutions.
- Wet sludge mass = dry solids/(1 − moisture fraction).
- Sludge volume = wet mass/(specific gravity × density of water).
- V₁/V₂ = (100 − p₂)/(100 − p₁), assuming specific gravity unchanged.