Classify the following hydraulic devices based upon their mode of operation :
(I) Aqueduct
(II) Super passage
(III) Falls
(IV) Barrage/weir
(V) Dams
5 marks · directive: Classify
The core of a good answer
By what they do: aqueduct and super passage are cross drainage (conveyance) works (aqueduct takes the canal over a drain; super passage takes the drain over the canal), falls are canal regulation works that drop the bed and dissipate energy, barrages and weirs are diversion works that raise the level only slightly without significant storage, and dams are storage (impounding) works.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
The question wants a functional grouping with one line of reasoning for each device, not definitions alone. A short table is the best format.
Answer outline
Introduction
Hydraulic structures in an irrigation system are grouped by the job they perform: storage, diversion, conveyance across natural drainage, and regulation of canal flow.
(I) Aqueduct: cross drainage work
- Canal passes over the drain in a trough or barrel; the drain flows below freely when its high flood level is below the trough bottom.
(II) Super passage: cross drainage work
- Reverse of the aqueduct: the natural stream passes over the canal in a trough, and the canal flows below with a free surface.
(III) Falls: regulation and energy dissipation work
- Drop the canal bed where the ground slope is steeper than the bed slope and dissipate the surplus energy, by impact in a pool (Sarda type) or by a hydraulic jump at the toe of a glacis.
(IV) Barrage or weir: diversion work
- Raise the river water level by only a few feet to divert flow into canals; a barrage regulates the pond by gates, a weir by a raised crest; little storage.
(V) Dams: storage work
- Impound a reservoir and store water for later use, raising the water level significantly.
Conclusion
So the five fall into four groups: cross drainage (I, II), regulation (III), diversion (IV) and storage (V).
Examples and data to cite
- A syphon aqueduct and a canal syphon are the pressure-flow counterparts of the aqueduct and super passage.
Facts to remember
- Barrage: low-head diversion dam with gates that raises water by only a few feet; dam: built for storage in a reservoir, raising the level significantly (World Commission on Dams usage, as reported by Wikipedia).
- Aqueduct: canal over drain; super passage: drain over canal.
- Canal falls are built where the natural ground slope exceeds the canal bed slope.
- Diversion structures do not generally impound water in a reservoir.