Answer the following questions in about 150 words each :
What are transform and transcurrent faults? Illustrate them using neat sketches.
10 marks · answer in 150 words · directive: Illustrate
The core of a good answer
Both are near-vertical faults with horizontal (strike-slip) movement, but a transform fault is a plate boundary that ends abruptly where it meets another plate boundary (a ridge, a subduction zone or another transform) and slips in the sense opposite to that suggested by the apparent offset of the ridge, whereas a transcurrent fault is not a plate boundary and may die out without meeting another fault.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
The question asks for definitions of the two terms and a clear contrast between them, supported by sketches. In 150 words the answer should define each, draw a ridge-transform-ridge sketch with relative motion arrows and a fracture zone, draw a map view of a transcurrent fault with offset markers, and tabulate the differences.
Answer outline
Introduction
Faults on which the slip vector is parallel to the strike are strike-slip faults; transform and transcurrent faults are two kinds of strike-slip faults that differ in their tectonic setting and termination.
Transform fault
- Proposed by J. Tuzo Wilson (1965) as a new class of faults; a conservative plate boundary where lithosphere is neither gained nor lost.
- Ends abruptly where it connects to another plate boundary: another transform, a spreading ridge or a subduction zone.
- Commonly offsets mid-ocean ridge segments separated by only tens of kilometres; fracture zones are the previously active transform lines that have moved beyond the active transform zone.
- Sense of slip is opposite to that suggested by the apparent offset of the ridge, and the slip does not increase the distance between the ridge segments; the hypothesis was confirmed by fault plane solutions of earthquakes (Sykes, 1967).
- Sketch: two ridge segments offset by a transform, half arrows showing opposite motion only along the active segment, fracture zones as dashed extensions, spreading arrows away from each ridge.
Transcurrent fault
- Another name for a strike-slip (wrench or tear) fault; it is not a plate boundary, its motion is horizontal with very little vertical movement, and its plane is ideally vertical.
- Unlike a transform, a transcurrent fault may die out without a junction with another fault.
- Sketch: map view of a vertical fault cutting a dyke or bed, with the marker displaced and half arrows showing dextral or sinistral sense; a block diagram shows horizontal slip on the plane.
Key differences
- Setting: plate boundary versus not a plate boundary.
- Termination: always at a junction with another plate boundary versus possibly dying out without a junction.
- Apparent offset: for a transform, the ridge offset does not grow with slip, so it is not a measure of displacement.
Conclusion
Transform faults are a special plate-boundary class of strike-slip fault, while transcurrent faults are strike-slip faults that are not plate boundaries; sketches should show this contrast in motion and termination.
Examples and data to cite
- San Andreas Fault, California: a transform linking the East Pacific Rise to the Mendocino triple junction.
- Alpine Fault, South Island of New Zealand: a transform boundary for much of its length with dextral strike-slip movement; Harold Wellman proposed about 480 km of lateral displacement on it.
- Romanche, St. Paul, Chain and Ascension fracture zones of the Atlantic, with deep, easily identifiable transform faults.
- J. Tuzo Wilson, 'A new class of faults and their bearing on continental drift', 1965.
Facts to remember
- Transform faults are also called conservative plate boundaries.
- Fracture zones are the previously active transform-fault lines that have passed beyond the active transform zone.
- A transform fault is a special case of a strike-slip fault.
- Dextral (right-lateral): the block across the fault moves to the right as seen from the other side; sinistral (left-lateral): to the left.