A laser beam delivers 5 J of energy in 0·01 sec over an area of 0·5 mm². Calculate the power density of the laser beam.
10 marks · directive: Calculate
Answer
The core of a good answer
Power = 5 J/0·01 s = 500 W, so power density = 500 W/0·5 mm² = 1000 W/mm² = 10⁵ W/cm² = 10⁹ W/m².
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
A direct calculation of irradiance: power is energy per unit time and power density is power per unit area. The answer should state units carefully and comment on whether the value suits machining.
Answer outline
Introduction
Energy E = 5 J, pulse duration t = 0·01 s, spot area A = 0·5 mm² = 5 × 10⁻⁷ m².
Step 1: Power
- P = E/t = 5/0·01 = 500 W
Step 2: Power density
- I = P/A = 500/0·5 = 1000 W/mm²
- = 10⁵ W/cm² = 10⁹ W/m² = 1 GW/m²
Step 3: Interpretation
- Laser machining removes material by melting and vaporisation, which needs a very high power density at the spot; the same energy delivered in a shorter pulse or on a smaller spot gives a proportionally higher density
- Energy density (fluence) = 5 J/0·5 mm² = 10 J/mm²
Step 4: Factors that change it
- Halving the spot diameter quarters the area and raises power density four times
- Shortening the pulse at constant energy raises the power in proportion
Conclusion
Power density = 1000 W/mm² (10⁵ W/cm²). Check by units: J/(s·mm²) = W/mm². (Recomputed in Python.)
Examples and data to cite
- Laser beam machining uses thermal energy to melt and vaporise material and is used for drilling and cutting; the beam can reach about 100 MW per square millimetre.
- Focusing the same beam to a smaller spot raises power density as 1/area.
Facts
Facts to remember
- Power P = E/t.
- Power density (irradiance) I = P/A, the power received per unit area, SI unit W/m².
- 1 W/mm² = 100 W/cm² = 10⁶ W/m².
- Fluence (radiant exposure) = energy per unit area, J/m².