A strip of width 250 mm is reduced from 30 mm to 20 mm thickness in a rolling mill of roll radius 400 mm. Considering coefficient of friction 0·25 and average flow stress 300 MPa, find the following :
(i) Contact length
(ii) Rolling force
(iii) Check if the biting condition is satisfied
10 marks · directive: Find
The core of a good answer
Contact length L = √(RΔh) = √(400 × 10) = 63·2 mm; rolling force F ≈ L w σ̄ = 4·74 MN (mean roll pressure taken equal to the average flow stress); the bite is satisfied because Δh = 10 mm is less than the maximum draft μ²R = 25 mm (tan α = 0·160 < μ = 0·25).
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
Flat rolling estimates. Contact (projected) length from geometry, roll force as flow stress times contact area (with an optional friction correction), and the bite condition that the roll can draw the strip in: μ ≥ tan α, equivalently Δh_max = μ²R.
Answer outline
Introduction
Data: w = 250 mm, h₀ = 30 mm, h_f = 20 mm, Δh = 10 mm, R = 400 mm, μ = 0·25, σ̄ = 300 MPa.
Step 1: Contact length (i)
- L ≈ √(RΔh) = √(400 × 10) = 63·25 mm
Step 2: Rolling force (ii)
- Estimate with mean roll pressure equal to the average flow stress (friction hill neglected)
- F = L w σ̄ = 63·25 × 250 × 300 = 4·743 × 10⁶ N = 4·74 MN
- Friction raises the actual mean pressure, so this is a lower estimate
Step 3: Bite condition (iii)
- Contact angle: cos α = 1 − Δh/(2R) = 0·9875, α = 9·07°
- tan α = 0·160 < μ = 0·25, so the strip is drawn in
- Equivalently Δh_max = μ²R = 0·0625 × 400 = 25 mm > 10 mm: satisfied
- Maximum bite angle = tan⁻¹0·25 = 14·04°
Step 4: Remarks
- True strain = ln(30/20) = 0·405
- Projected contact length from geometry: L = √(RΔh − Δh²/4) = 63·05 mm, so the approximation √(RΔh) differs by about 0·3%
Conclusion
L = 63·2 mm, F ≈ 4·74 MN, and the bite condition is met with a large margin. (Recomputed in Python.)
Examples and data to cite
- The maximum draft μ²R shows why larger rolls or higher friction allow heavier reductions in one pass.
Facts to remember
- Projected contact length L ≈ √(RΔh) (geometry of the arc of contact).
- Roll force estimate F ≈ L w σ̄ (contact area times mean flow stress).
- Bite condition: μ ≥ tan α; maximum draft Δh_max = μ²R.
- Contact angle from cos α = 1 − Δh/(2R).