A shaft of nominal size 60 mm is to be fitted into a hole. The tolerances are :
Hole tolerance – 0·030 mm
Shaft tolerance – 0·020 mm
Minimum clearance required – 0·010 mm
Determine the following :
(i) Maximum clearance
(ii) Hole and shaft limits
(iii) Allowance
10 marks · directive: Determine
The core of a good answer
On the hole basis system the hole is 60·000 to 60·030 mm and the shaft 59·970 to 59·990 mm; maximum clearance = 60·030 − 59·970 = 0·060 mm and the allowance (minimum clearance) is 0·010 mm.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
A limits and fits calculation. Choose a basis (hole basis is standard practice: lower deviation of the hole zero), place the shaft upper limit below the hole's lower limit by the minimum clearance, then subtract the shaft tolerance. Maximum clearance = hole tolerance + shaft tolerance + allowance.
Answer outline
Introduction
Basic size 60 mm; hole tolerance 0·030 mm; shaft tolerance 0·020 mm; minimum clearance 0·010 mm. Hole basis system assumed.
Step 1: Hole limits
- Lower limit = 60·000 mm (fundamental deviation H, zero)
- Upper limit = 60·000 + 0·030 = 60·030 mm
Step 2: Shaft limits
- Upper limit = 60·000 − 0·010 = 59·990 mm
- Lower limit = 59·990 − 0·020 = 59·970 mm
Step 3: Maximum clearance (i)
- = largest hole − smallest shaft = 60·030 − 59·970 = 0·060 mm
- Check: 0·030 + 0·020 + 0·010 = 0·060 mm
Step 4: Allowance (iii)
- Allowance = minimum clearance = smallest hole − largest shaft = 60·000 − 59·990 = 0·010 mm
Note
- On a shaft basis system (shaft 59·980 to 60·000 mm, hole 60·010 to 60·040 mm) the clearances are the same: 0·010 mm minimum, 0·060 mm maximum
Conclusion
Hole 60·000/60·030 mm, shaft 59·970/59·990 mm, maximum clearance 0·060 mm, allowance 0·010 mm: a clearance fit. (Recomputed in Python.)
Examples and data to cite
- Running clearance fits in the ISO system include H11/c11 (loose), H9/d9 (free), H8/f7 (close) and H7/g6 (sliding).
- Standard tolerance grades and limits and fits are given in ISO 286-1.
Facts to remember
- Allowance is the intended difference between the hole and shaft limits; on the hole basis it equals the shaft's fundamental deviation, here the minimum clearance.
- Maximum clearance = largest hole − smallest shaft; minimum clearance = smallest hole − largest shaft.
- Hole basis: the hole size is held constant and the H hole has lower deviation zero.
- Fit tolerance = hole tolerance + shaft tolerance.