The air-fuel ratio of an SI engine varies under different operating conditions. Write the air-fuel ratio requirement for an engine under the following conditions with reasons :
(i) Idling or no-load condition
(ii) Cruising or part-load condition
(iii) Maximum power or full-load condition
10 marks · directive: Write
The core of a good answer
Against a stoichiometric ratio of about 14.7:1 for petrol, a lean mixture (around 16:1, the maximum-economy ratio) suits cruising or part load, and a rich mixture (about 12:1 to 13.3:1) suits maximum power at full load, where the richer mixture also gives cooler combustion products and helps prevent detonation. The idling requirement (i) is left out because no opened source states it.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
Explain the mixture requirement in each operating range with reasons from economy, power and combustion. Part (i) (idling) is left out of this outline: no standard source stating the idling mixture requirement could be opened.
Answer outline
Introduction
The stoichiometric air-fuel mixture for petrol is about 14.7:1 by mass. λ is the actual air-fuel ratio divided by the stoichiometric ratio: λ = 1 at stoichiometry, λ < 1 rich, λ > 1 lean.
(ii) Cruising or part-load: lean, about 16:1
- The engine runs mostly in this range, so economy matters
- A ratio of about 16:1 gives maximum economy; maximum power is not demanded
(iii) Maximum power or full-load: rich, about 12:1 to 13.3:1
- Naturally aspirated petrol engines often give peak power at air-fuel ratios of about 12.5:1 to 13.3:1; about 12:1 is quoted as the maximum-output ratio
- At high load a richer mixture is used to produce cooler combustion products, which helps prevent detonation
- Economy is sacrificed for power
Carburettor provisions
- An idle jet, set by the manufacturer, supplies fuel at small throttle openings where the air speed cannot maintain the main fuel flow
- A power valve opens as manifold vacuum falls under load, giving extra fuel at high loads
- Extra fuel is also needed for cold starting, because cold fuel vaporises less readily
Conclusion
Lean for economy at part load, rich for power and detonation control at full load, with stoichiometric (λ = 1) as the reference.
Examples and data to cite
- Carburettors supply these needs through the idle jet, the main circuit and a vacuum-operated power valve.
- Catalytic converters are designed to work best when combustion is close to complete, which favours near-stoichiometric operation.
Facts to remember
- Stoichiometric A/F for petrol ≈ 14.7:1.
- Maximum-output mixture about 12:1 (peak power often 12.5 to 13.3:1); maximum-economy mixture about 16:1.
- λ = actual A/F ÷ stoichiometric A/F; equivalence ratio Φ > 1 means excess fuel.