How are the ratings of SI and CI engine fuels done? Explain in brief.
10 marks · directive: Explain
The core of a good answer
SI engine fuels are rated by octane number, the percentage by volume of iso-octane in an iso-octane and n-heptane blend that has the same knock resistance in a variable-compression test engine (Research and Motor methods); CI engine fuels are rated by cetane number, the percentage by volume of n-cetane in a blend with α-methyl naphthalene (now heptamethylnonane) that gives the same ignition delay as the test fuel.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
Explain the two rating scales: what property each measures (knock resistance against ignition quality), the reference fuels, the test procedure on a standard variable-compression engine and the meaning of high and low numbers.
Answer outline
Introduction
Knock in an SI engine is auto-ignition of the end gas, so SI fuels must resist self-ignition. Knock in a CI engine comes from a long ignition delay, so CI fuels must self-ignite readily. The two ratings therefore run in opposite directions.
Octane number (SI fuels)
- Reference fuels: iso-octane (2,2,4-trimethylpentane) = 100, n-heptane = 0
- Test in a single-cylinder engine with variable compression ratio, comparing the knock of the test fuel with iso-octane and n-heptane blends
- Octane number = volume percent of iso-octane in the matching blend
- Research Octane Number (RON, 600 rpm) and Motor Octane Number (MON, 900 rpm, preheated mixture, variable ignition timing); MON is typically 8 to 12 points below RON for pump petrol; sensitivity = RON − MON; anti-knock index (RON + MON)/2
- Ratings above 100 are expressed as performance numbers
Cetane number (CI fuels)
- Reference fuels: n-cetane (n-hexadecane) = 100, α-methyl naphthalene = 0, now replaced by isocetane (heptamethylnonane) with cetane number 15
- Test in a CFR engine: the compression ratio is adjusted until the time from injection to ignition is 2.407 ms, and the matching cetane-isocetane blend is found
- Cetane number = per cent n-cetane + 0.15 × per cent isocetane, by volume, in the matching blend
- Higher cetane number means shorter ignition delay
Related index
- Cetane index: a calculated estimate from fuel density and distillation temperatures; it cannot account for cetane-improving additives
Conclusion
SI fuels are rated by resistance to auto-ignition (octane number) and CI fuels by readiness to auto-ignite (cetane number), each against a pair of reference hydrocarbons in a standardised engine test.
Examples and data to cite
- Aviation fuel 100LL has a lean rating of 100 and a rich rating of 130.
- EN 590 diesel in Europe requires a minimum cetane number of 51; the cetane test method is ASTM D613.
Facts to remember
- Octane number: % iso-octane in iso-octane/n-heptane blend of equal knock resistance.
- Cetane number: % cetane in a cetane/isocetane blend of equal ignition delay.
- RON is measured at 600 rpm, MON at 900 rpm.