What is the photovoltaic effect? What are the processes that are required to obtain a useful power output from photon interactions in a semiconductor? List the factors that affect the efficiency of a solar cell.
15 marks · directive: Explain
The core of a good answer
The photovoltaic effect is the generation of a voltage and current in a material, typically a p-n junction, when it absorbs light; useful power needs absorption of photons with hν ≥ E_g to create electron-hole pairs, separation of the pairs by the junction's built-in field before they recombine, and collection at the contacts to drive current through a load. Efficiency depends on band gap (spectral losses; Shockley-Queisser limit about 33.7% for one junction under AM1.5, with the optimum gap near 1.34 eV), recombination, reflection and shading, fill factor, temperature, and light intensity and spectrum.
An outline written by upsc.help, not an official UPSC answer; every fact checked by a separate review. How we work
What the question asks
A descriptive 15-mark answer in three parts: definition with the junction physics, the generation-separation-collection chain, and a classified list of efficiency factors. An I-V characteristic with V_oc, I_sc and fill factor strengthens the answer.
Answer outline
Introduction
Observed by Edmond Becquerel (1839). In a solar cell a p-n junction with a depletion region and built-in field converts absorbed photon energy into electrical energy.
Photovoltaic effect
- Illumination of a junction produces an open-circuit voltage V_oc and short-circuit current I_sc without external bias
- The cell behaves as a diode in parallel with a light-generated current source
- Power P = V I is largest at the maximum power point; the fill factor describes how square the I-V curve is
Processes needed
- Absorption: photons with hν ≥ E_g create electron-hole pairs; photons below E_g pass through
- Thermalisation: excess energy hν − E_g is lost as heat almost at once
- Separation: carriers generated in or within a diffusion length of the depletion region are swept apart by the built-in field (electrons to n side, holes to p side)
- Collection: carriers reach the contacts and flow through the external load before recombining; this builds the photovoltage
Factors affecting efficiency
- Band gap: sub-gap photons lost, excess energy lost as heat; detailed-balance limit about 33.7% for a single junction under AM1.5, optimum gap near 1.34 eV
- Recombination: radiative (unavoidable), Auger and defect-related recombination reduce collected current and V_oc
- Optical losses: front-surface reflection (reduced by anti-reflection coatings and texturing) and grid shading
- Fill factor: depends on the shape of the I-V curve and on illumination
- Temperature: V_oc falls as temperature rises, lowering efficiency
- Illumination: concentration raises the limit somewhat, unless the cell overheats; spectrum also matters
- Material quality: defects and grain boundaries, and carrier mobility, lower efficiency
Conclusion
Solar cells convert light to electricity by generating, separating and collecting carriers; single-junction efficiency is bounded near 33.7%, and practical cells lose further through recombination, optical and resistive losses and heating.
Facts to remember
- Photovoltaic effect discovered by Becquerel, 1839.
- Only photons with hν ≥ E_g generate carriers.
- Shockley-Queisser limit: about 33.7% for a single junction under AM1.5, optimum band gap near 1.34 eV.
- Efficiency is limited by sub-gap losses, thermalisation, recombination, reflection and shading, and temperature.